At the end of a trial, the hypothesis is either rejected or accepted. Denote the stage number and the statistic at the end of a trial by a pair of statistics , where k is the stage number and z is the standardized Z statistic. Then an ordering on the sample space is needed to derive the pvalue, median, and confidence limits associated with the observed statistics .
The SEQTEST procedure provides the stagewise, LR, and MLE orderings. See Jennison and Turnbull (2000, pp. 179–187) for a detailed description and comparison of these orderings.
If the continuation regions of a design are intervals, the stagewise ordering (Fairbanks and Madsen 1982; Tsiatis, Rosner, and Mehta 1984; Jennison and Turnbull 2000, pp. 179–180) uses counterclockwise ordering around the continuation region to compute the pvalue, unbiased median estimate, and confidence limits. This ordering depends on the stopping region, stopping stage, and standardized statistic at the stopping stage. But it does not depend on information levels beyond the observed stage. For a onesided design with an upper alternative, if one of the following criteria holds:
and
and , the upper boundary at stage
and , the upper boundary at stage k
Similar criteria can be derived for a onesided design with a lower alternative.
For a twosided design with early stopping to reject the null hypothesis, if one of the following criteria holds:
and
and , the upper boundary at stage
and , the lower boundary at stage k
Note that the stagewise ordering is not applicable for twosided designs with early stopping to accept or to either accept or reject , which might have two disjoint continuous intervals at each interim stage.
For a twosided design with early stopping either to reject or to accept the null hypothesis, if one of the following criteria holds:
and
and
That is, each value in the continuation region is less extreme than each value in the upper rejection region and more extreme than each value in the lower rejection region. Then, combining with the ordering defined for a twosided design with early stopping to reject the null hypothesis, the pvalue, median, and confidence limits can be derived for the observed statistics in the lower or upper rejection region.
Thus, if the stagewise ordering is specified in the SEQTEST procedure for a twosided design with early stopping to either reject or accept the null hypothesis, the stagewise ordering is used to derive these statistics only if the observed statistics is in the lower or upper rejection region. Otherwise, the LR ordering is used.
The LR ordering (Chang, 1989) depends on the observed standardized Z statistic z, information levels, and a specified hypothetical reference. For the LR ordering under a given hypothesis , if

Under the null hypothesis , it reduces to

and can be used to derive statistics under , such as pvalues.
The LR ordering is applicable to all designs if all information levels are available. But depending on the boundary shape, some observed statistics in the rejection region might be less extreme than the statistics in the acceptance region. That is, the pvalue for observed statistics in the rejection region might be greater than the significance level.
The MLE ordering (Emerson and Fleming, 1990) depends only on the observed maximum likelihood estimate. if

The MLE ordering is applicable to all designs if all information levels are available.