XCHART Statement: ANOM Procedure

Note: See ANOM Charts Using LIMITS= Data Set in the SAS/QC Sample Library.

In Example 4.5, statistics from a two-way ANOVA were passed to the ANOM procedure using options in order to compute the decision limits for the factor effects. This example shows how you can pass the statistics in a LIMITS= data set using the variables _MSE_ and _DFE_.

The GLM output in Output 4.5.1 provides the statistics. The following statements save the results from PROC GLM in the data sets MyFit, MyMeans, and MyOverAll:

ods select FitStatistics ModelANOVA OverAllANOVA;
ods output FitStatistics = MyFit
           ModelANOVA    = MyLimits
           OverAllANOVA  = MyOverAll;

proc glm data=Cleaning;
   class position depth;
   model concentration = position depth position*depth;
run;

The results of PROC GLM are identical to the results in Output 4.5.1.

The following statements create a LIMITS= data set to be used to create an ANOM chart for the effect of Position:

data ANOMParms; 
   keep _var_ _group_ _alpha_ _mean_;
      length _var_ _group_ $ 14;
   set MyFit (rename=(Dependent=_var_ DepMean  =_mean_));
      _group_ = 'position';
      _alpha_ = 0.05;
run;

data ANOMParms;
   merge ANOMParms
         MyLimits (where=(source='position')
                   keep = source DF);
   _limitk_ = DF+1;
   drop source DF;
   merge MyOverAll (where=(source='Error') 
            keep = source df ms
            rename=( df = _dfe_ ms = _mse_));
   drop source;
   merge MyOverAll (where=(source='Corrected Total')
                    keep = source DF);
   _limitn_ = (DF+1)/_limitk_;                    
   drop source DF;
run;

The data set ANOMParms contains a complete set of parameters, as shown in Output 4.6.1. Note these are the same values specified in the options for Example 4.5.

The following statements read the parameters in ANOMParms to create an ANOM chart for the effect of position:

ods graphics on;
title "ANOM for Effect of Position";
proc anom data=Cleaning limits=ANOMParms;
   xchart concentration * position /
      outtable = postable
      odstitle = title;
   label position      = 'Position'
         concentration = 'Mean of Concentration';
run; 

The chart produced is identical to the one in Output 4.5.2. Note that the procedure creates a TABLE= input data set postable. You can use postable to create a combined chart for the two factors position and depth.

You can create a LIMITS= data set ANOMParmsB for the factor depth by using the above code and substituting 'depth' for the _group_ variable. You can use the OUTTABLE= statement to store the TABLE= input data set for depth as deptable. The resulting data set ANOMParmsB is shown in Output 4.6.2: