The SURVEYLOGISTIC Procedure
- Overview
- Getting Started
-
Syntax
PROC SURVEYLOGISTIC Statement BY Statement CLASS Statement CLUSTER Statement CONTRAST Statement DOMAIN Statement EFFECT Statement ESTIMATE Statement FREQ Statement LSMEANS Statement LSMESTIMATE Statement MODEL Statement OUTPUT Statement REPWEIGHTS Statement SLICE Statement STORE Statement STRATA Statement TEST Statement UNITS Statement WEIGHT Statement -
Details
Missing Values Model Specification Model Fitting Survey Design Information Logistic Regression Models and Parameters Variance Estimation Domain Analysis Hypothesis Testing and Estimation Linear Predictor, Predicted Probability, and Confidence Limits Output Data Sets Displayed Output ODS Table Names ODS Graphics
-
Examples
- References
| MODEL Statement |
- MODEL events/trials = <effects </ options>> ;
- MODEL variable <(v-options)> = <effects> </ options> ;
The MODEL statement names the response variable and the explanatory effects, including covariates, main effects, interactions, and nested effects; see the section Specification of Effects of Chapter 41, The GLM Procedure, for more information. If you omit the explanatory variables, the procedure fits an intercept-only model. Model options can be specified after a slash (/).
Two forms of the MODEL statement can be specified. The first form, referred to as single-trial syntax, is applicable to binary, ordinal, and nominal response data. The second form, referred to as events/trials syntax, is restricted to the case of binary response data. The single-trial syntax is used when each observation in the DATA= data set contains information about only a single trial, such as a single subject in an experiment. When each observation contains information about multiple binary-response trials, such as the counts of the number of subjects observed and the number responding, then events/trials syntax can be used.
In the events/trials syntax, you specify two variables that contain count data for a binomial experiment. These two variables are separated by a slash. The value of the first variable, events, is the number of positive responses (or events), and it must be nonnegative. The value of the second variable, trials, is the number of trials, and it must not be less than the value of events.
In the single-trial syntax, you specify one variable (on the left side of the equal sign) as the response variable. This variable can be character or numeric. Options specific to the response variable can be specified immediately after the response variable with parentheses around them.
For both forms of the MODEL statement, explanatory effects follow the equal sign. Variables can be either continuous or classification variables. Classification variables can be character or numeric, and they must be declared in the CLASS statement. When an effect is a classification variable, the procedure enters a set of coded columns into the design matrix instead of directly entering a single column containing the values of the variable.