SVGX= System Option

Specifies the x-axis coordinate of one corner of the rectangular region into which an embedded <svg> element is placed; specifies the x attribute in the outermost <svg> element in an SVG file.

Valid in:	Configuration file, SAS invocation, OPTIONS statement, SAS System Options window
Category:	Log and procedure output control: SVG
PROC OPTIONS GROUP=	SVG
Restriction:	The SVGX= option sets the x attribute only on the outermost <svg> element.
Note:	This option can be restricted by a site administrator. For more information, see Restricted Options.

Syntax

Details

Syntax

SVGX= number-of-units < unit-of-measure > | "" | ''

Syntax Description

number-of-units: specifies the x-axis coordinate as a number of unit-of-measure.

unit-of-measure

specifies the unit of measurement, which can be one of the following:

%	percentage
cm	centimeters
em	the height of the element's font
ex	the height of the letter x
in	inches
mm	millimeters
pc	picas
pt	points
px	pixels

Default:px

"" | '': specifies to reset the x attribute to 0 on the <svg> element and the x-axis coordinate for embedded SVG to 0.

Requirement:Use two double quotation marks or two single quotation marks with no space between them.

Details

If the SVGX= option is not set, the x attribute on the <svg> element effectively has a value of 0 and no x-axis coordinate is set for embedded SVG output.

The value for the SVGX= option can be specified without delimiters, enclosed in single or double quotation marks, or enclosed in parentheses.

The x attribute on the outermost <svg> element has no effect on SVG documents that are produced by SAS. You can use the SVGX= system option to specify the x-axis coordinate if the SVG document is processed outside of SAS.

SVGX= System Option

Syntax

Syntax Description

Details

See Also