This document uses the
terms
configuring and
removing
a configuration (unconfiguring) in the following ways.
-
In addition to installing
products, the SAS automated deployment tools also configure products.
In most deployment scenarios, you install and configure in one SAS
Deployment Wizard session. But, because the deployment wizard enables
you to separate installation and configuration into separate tasks,
it is possible that you can install a SAS product and then configure
it later by rerunning the wizard. Therefore, you
configure SAS
products that have been installed on your system that have not yet
been configured.
Your SAS configuration
is affected when you add SAS products to deployment that require configuration.
-
Deleting one or more
product configurations is referred to as removing a configuration.
The following scenarios for removing SAS product configurations are
common:
-
uninstalling a SAS product
-
adding new SAS products that require
you to remove the current configuration before configuring it again
-
correcting configuration errors