The INTPOINT Procedure
-
Overview
-
Getting Started
-
SyntaxFunctional SummaryDictionary of OptionsPROC INTPOINT StatementCAPACITY StatementCOEF StatementCOLUMN StatementCOST StatementDEMAND StatementHEADNODE StatementID StatementLO StatementNAME StatementNODE StatementQUIT StatementRHS StatementROW StatementRUN StatementSUPDEM StatementSUPPLY StatementTAILNODE StatementTYPE StatementVAR Statement
-
DetailsInput Data SetsOutput Data SetsConverting Any PROC INTPOINT Format to an MPS-Format SAS Data SetCase SensitivityLoop ArcsMultiple ArcsFlow and Value BoundsTightening Bounds and Side ConstraintsReasons for InfeasibilityMissing S Supply and Missing D Demand ValuesBalancing Total Supply and Total DemandHow to Make the Data Read of PROC INTPOINT More EfficientStopping Criteria
-
ExamplesProduction, Inventory, Distribution ProblemAltering Arc DataAdding Side ConstraintsUsing Constraints and More Alteration to Arc DataNonarc Variables in the Side ConstraintsSolving an LP Problem with Data in MPS FormatConverting to an MPS-Format SAS Data SetMigration to OPTMODEL: Production, Inventory, Distribution
- References
If any piece of data is furnished to PROC INTPOINT more than once, PROC INTPOINT checks for consistency so that no conflict exists concerning the data values. For example, if the cost of some arc is seen to be one value and as more data are read, the cost of the same arc is seen to be another value, PROC INTPOINT issues an error message on the SAS log and stops. There are two exceptions to this:
-
The bounds of arcs and nonarc variables, or the bounds of LP variables, are made as tight as possible. If several different values are given for the lower flow bound of an arc, the greatest value is used. If several different values are given for the lower bound of a nonarc or LP variable, the greatest value is used. If several different values are given for the capacity of an arc, the smallest value is used. If several different values are given for the upper bound of a nonarc or LP variable, the smallest value is used.
-
Several values can be given for inequality constraint right-hand sides. For a particular constraint, the lowest rhs value is used for the rhs if the constraint is of less than or equal to type. For a particular constraint, the greatest rhs value is used for the rhs if the constraint is of greater than or equal to type.