The TEST statement performs a hypothesis test on the fixed effects. You can specify multiple effects in one TEST statement
or in multiple TEST statements, and all TEST statements must appear after the MODEL
statement.
You can specify the following options in the TEST statement after a slash (/).

HTYPE=valuelist

indicates the type of hypothesis test to perform on the specified effects. Valid entries for values in the valuelist are 3, corresponding to a Type III test. The default value is 3. The ODS table name is "Tests3" for the Type III test.

E

requests that matrix coefficients associated with test types be displayed for specified effects.

E3  EIII

requests that Type III matrix coefficients be displayed if a Type III test is performed.

CHISQ

requests that tests be performed in addition to any F tests. A statistic equals its corresponding F statistic times the associate numerator degree of freedom, and this same degree of freedom is used to compute the pvalue for the test. This pvalue will always be less than that for the F test, because it effectively corresponds to an F test with infinite denominator degrees of freedom.