###
Creating a Data Set Containing the Crosstabulation

The CORRESP procedure can read or create a contingency or Burt table. PROC CORRESP is generally more efficient with VAR statement
input than with TABLES statement input. TABLES statement input requires that the table be created from raw categorical variables,
whereas the VAR statement is used to read an existing table. For extremely large problems, if PROC CORRESP runs out of memory,
it might be possible to use some other method to create the table and then use VAR statement input with PROC CORRESP.

The following example uses the CORRESP, FREQ, and TRANSPOSE procedures to create rectangular tables from a SAS data set WORK.A
that contains the categorical variables `V1`

–`V5`

. The Burt table examples assume that no categorical variable has a value found in any of the other categorical variables
(that is, that each row and column label is unique).

You can use PROC CORRESP and the ODS OUTPUT statement as follows to create a rectangular two-way contingency table from two
categorical variables:

proc corresp data=a observed short;
ods output Observed=Obs(drop=Sum where=(Label ne 'Sum'));
tables v1, v2;
run;

You can use PROC FREQ and PROC TRANSPOSE to create a rectangular two-way contingency table from two categorical variables,
as in the following statements:

proc freq data=a;
tables v1 * v2 / sparse noprint out=freqs;
run;
proc transpose data=freqs out=rfreqs(drop=_:);
id v2;
var count;
by v1;
run;

You can use PROC CORRESP and the ODS OUTPUT statement as follows to create a Burt table from five categorical variables:

proc corresp data=a observed short mca;
ods output Burt=Obs;
tables v1-v5;
run;

You can use a DATA step, PROC FREQ, and PROC TRANSPOSE to create a Burt table from five categorical variables, as in the following
statements:

data b;
set a;
array v[5] $ v1-v5;
do i = 1 to 5;
row = v[i];
do j = 1 to 5;
column = v[j];
output;
end;
end;
keep row column;
run;
proc freq data=b;
tables row * column / sparse noprint out=freqs;
run;
proc transpose data=freqs out=rfreqs(drop=_:);
id column;
var count;
by row;
run;