SCHART Statement: SHEWHART Procedure

Example 15.30 Computing Average Run Lengths for s Charts

[See SHWSARL in the SAS/QC Sample Library]This example illustrates how you can compute the average run length of an chart. The data used here are the power measurements in the data set Turbine, which is introduced in Creating Standard Deviation Charts from Raw Data.

The in-control average run length of a Shewhart chart is , where is the probability that a single point exceeds its control limits. Since this probability is saved as the value of the variable _ALPHA_ in an OUTLIMITS= data set, you can compute ARL for an chart as follows:

title 'Average In-Control Run Length';
proc shewhart data=Turbine;
   schart KWatts*Day / outlimits=Turblim nochart;

data ARLcomp;
   keep _var_ _sigmas_ _alpha_ arl;
   set Turblim;
   arl = 1 / _alpha_;
run;

The data set ARLcomp is listed in Output 15.30.1, which shows that the ARL is equal to 358.

To compute out-of-control average run lengths, define as the slippage factor for the process standard deviation , where . In other words, the "shifted" standard deviation to be detected by the chart is . The following statements compute the ARL as a function of :

data ARLshift;
   keep f f_std p arl_f;
   set Turblim;
   df = _limitn_ - 1;
   do f = 1 to 1.5 by 0.05;
      f_std = f * _stddev_;
      low   = df * ( _lcls_ / f_std )**2;
      upp   = df * ( _ucls_ / f_std )**2;
      p     = probchi( low, df ) + 1 - probchi( upp, df );
      arl_f = 1 / p;
      output;
   end;
run;

The data set ARLshift is listed in Output 15.30.2. For example, on average, 53 samples are required to detect a ten percent increase in (a shifted standard deviation of approximately 219). The computations use the fact that has a distribution with degrees of freedom, assuming that the measurements are normally distributed.