 |
|
| The CAPABILITY Procedure |
SYMBOL Statement Options
In earlier releases of SAS/QC software, graphical features of lower and upper specification lines and diagonal distribution reference lines were controlled with options in the SYMBOL2, SYMBOL3, and SYMBOL4 statements, respectively. These options are still supported, although they have been superseded by options in the PROBPLOT and SPEC statements. The following table summarizes the two sets of options:
Statement |
Alternative Statement |
||||
|---|---|---|---|---|---|
Feature |
and Options |
and Options |
|||
Symbol markers |
SYMBOL1 Statement |
||||
character |
VALUE=special-symbol |
||||
color |
COLOR=color |
||||
font |
FONT=font |
||||
height |
HEIGHT=value |
||||
Lower specification line |
SPEC Statement |
SYMBOL2 Statement |
|||
position |
LSL=value |
||||
color |
CLSL=color |
COLOR=color |
|||
line type |
LLSL=linetype |
LINE=linetype |
|||
width |
WLSL=value |
WIDTH=value |
|||
Upper specification line |
SPEC Statement |
SYMBOL3 Statement |
|||
position |
USL=value |
||||
color |
CUSL=color |
COLOR=color |
|||
line type |
LUSL=linetype |
LINE=linetype |
|||
width |
WUSL=value |
WIDTH=value |
|||
Target reference line |
SPEC Statement |
||||
position |
TARGET=value |
||||
color |
CTARGET=color |
||||
line type |
LTARGET=linetype |
||||
width |
WTARGET=value |
||||
Distribution reference line |
PROBPLOT Statement |
SYMBOL4 Statement |
|||
color |
COLOR=color |
COLOR=color |
|||
line type |
LINE=linetype |
LINE=linetype |
|||
width |
WIDTH=value |
WIDTH=value |
|||
For an illustration of these options, see Example 5.19.
|
|
Copyright © SAS Institute, Inc. All Rights Reserved.