SAS Data Quality Server System Options: SAS Data Quality Server System Options

SAS Data Quality Server System Options

The SAS Data Quality Server system options DQLOCALE= and DQSETUPLOC= must be asserted before you run data cleansing programs. The DQOPTIONS= system option is used at SAS invocation to set data quality parameters.

To specify values for the DQLOCALE= and DQSETUPLOC= system options, use the %DQLOAD AUTOCALL macro. See %DQLOAD AUTOCALL Macro.

Note: It is not recommended that you specify these system options by any means other than invoking the AUTOCALL macro %DQLOAD. Failure to use %DQLOAD or misapplied use of default settings for these system options can result in data that is cleansed with inappropriate locales. [cautionend]

The DQOPTIONS= system option enables you to optimize your SAS session for data quality. The value of the system option is a set of option-value pairs that you specify on the SAS start-up command or in the SAS configuration file.

The data quality system options can be referenced by the OPTIONS procedure by specifying GROUP=DATAQUALITY.

Top of Page