Let be the set of indices and let be the set of values for a finite population of size N. The survival time of each member of the finite population is assumed to follow its own hazard function, , expressed as

where is an arbitrary and unspecified baseline hazard function, is the vector of explanatory variables for the ith unit at time t, and is the vector of unknown regression parameters that are associated with the explanatory variables. The vector is assumed to be the same for all individuals.
The partial likelihood function introduced by Cox (1972, 1975) eliminates the unknown baseline hazard and accounts for censored survival times. If the entire population is observed, then this partial likelihood can be used to estimate . Let be the desired estimator. Assuming a working model with uncorrelated responses, is obtained by maximizing the partial log likelihood,

with respect to , where L is Cox’s partial likelihood function.
Assume that probability sample A is selected from the finite population U and is the selection probability for unit i. Further assume that covariates and survival time are available for every unit in the sample A. An estimator of the finite population log likelihood is

See Partial Likelihood Function for the Cox Model for more details.
A samplebased estimator for the finite population quantity can be obtained by maximizing the partial pseudologlikelihood with respect to . The designbased variance for is obtained by assuming the set of finite population values as fixed. For more information about maximum pseudolikelihood estimators and other inferential approaches for survey data, see Kish and Frankel (1974); Godambe and Thompson (1986); Pfeffermann (1993), Korn and Graubard (1999, chapter 3), Chambers and Skinner (2003, chapter 2), and Fuller (2009, section 6.5). Maximum pseudolikelihood estimators and their properties for Cox’s proportional hazards model for survey data are discussed in Binder (1990, 1992); Lin and Wei (1989); Lin (2000); Boudreau and Lawless (2006).
Without loss of generality, the rest of this section uses indices for stratified clustered designs. For a stratified clustered sample design, observations are represented by a matrix

where
denotes the vector of sampling weights
denotes the event time variable
denotes the event indicator
denotes the matrix of auxiliary information
is the stratum index
is the cluster index within stratum h
is the unit index within cluster i of stratum h
p is the total number of parameters
is the total number of observations in the sample
, where is an indicator function
, where is an indicator function
Let denote the summation over the set of indices such that the observation unit j in PSU i and stratum h belongs to the index set B. Typically, B is the set of all population indices that are in the sample, the risk set, or the set of all units with a failure.
The firststage sampling rate (fraction of PSUs selected for the sample) is denoted by . The firststage sampling rate is used in Taylor series variance estimation. You can specify the stratum sampling rates with the RATE= option. Or if you specify population totals with the TOTAL= option, PROC SURVEYFREQ computes as the ratio of stratum sample size to the stratum total, in terms of PSUs. See the section Population Totals and Sampling Rates for details. If you do not specify the RATE= option or the TOTAL= option, then the procedure assumes that the stratum sampling rates are negligible and does not use a finite population correction when computing variances.