MACHART Statement: MACONTROL Procedure

Example 9.6 Specifying Standard Values for the Process Mean and Process Standard Deviation

Note: See Standard Values for Moving Average Charts in the SAS/QC Sample Library.

By default, the MACHART statement estimates the process mean ($\mu $) and standard deviation ($\sigma $) from the data. This is illustrated in Getting Started: MACHART Statement. However, there are applications in which standard values ($\mu _0$ and $\sigma _0$) are available based, for instance, on previous experience or extensive sampling. You can specify these values with the MU0= and SIGMA0= options.

For example, suppose it is known that the metal clip manufacturing process (introduced in Creating Moving Average Charts from Raw Data) has a mean of 15 and standard deviation of 0.2. The following statements specify these standard values:

ods graphics on;
title 'Specifying Standard Process Mean and Standard Deviation';
proc macontrol data=Clips1;
   machart Gap*Day /
       odstitle = title
       mu0      = 15
       sigma0   = 0.2
       span     = 4
       xsymbol  = mu0
       markers;
run;

The XSYMBOL= option specifies the label for the central line. The resulting chart is shown in Output 9.6.1.

Output 9.6.1: Specifying Standard Values with MU0= and SIGMA0=

Specifying Standard Values with MU0= and SIGMA0=


The central line and control limits are determined using $\mu _0$ and $\sigma _0$ (see the equations in Table 9.9). Output 9.6.1 indicates that the process is out-of-control since the moving averages for Day=17, Day=19, and Day=20 lie below the lower control limit.

You can also specify $\mu _0$ and $\sigma _0$ with the variables _MEAN_ and _STDDEV_ in a LIMITS= data set, as illustrated by the following statements:

data cliplim;
   length _var_ _subgrp_ _type_ $8;
   _var_    = 'Gap';
   _subgrp_ = 'Day';
   _type_   = 'STANDARD';
   _limitn_ = 5;
   _mean_   = 15;
   _stddev_ = 0.2;
   _span_   = 4;
run;

proc macontrol data=Clips1 limits=Cliplim;
   machart Gap*Day / xsymbol=mu0
                     odstitle = title
                     markers;
run;

The variable _SPAN_ is required, and its value provides the number of terms in the moving average. The variables _VAR_ and _SUBGRP_ are also required, and their values must match the process and subgroup-variable, respectively, specified in the MACHART statement. The bookkeeping variable _TYPE_ is not required, but it is recommended to indicate that the variables _MEAN_ and _STDDEV_ provide standard values rather than estimated values.

The resulting chart (not shown here) is identical to the one shown in Output 9.6.1.