Defines the coordinate system and area of the output used by Y
and YC to display the Annotate graphics.
Type: |
character
|
Length: |
1
|
Default: |
4
|
YSYS='coordinate-system';
|
-
coordinate-system
-
specifies a value that represents a coordinate
system. Values can be 1 through 9 and A through C, as shown in the following
table:
Absolute Systems |
Relative Systems |
Coordinate System Units |
1 |
7 |
percentage of data area |
2 |
8 |
data values |
3 |
9 |
percentage of graphics output area |
4 |
A |
cell in graphics output area |
5 |
B |
percentage of procedure output area |
6 |
C |
cell in procedure output area |
These values are also used by
the HSYS and
XSYS variables. See Coordinate Systems for a description of the areas and coordinate
systems.
The YSYS variable is function-dependent,
as defined in the XSYS Variable
You can use the YSYS variable with these functions:
ARROW |
LABEL |
POINT |
BAR |
MOVE |
POLY |
DRAW |
PIE |
POLYCONT |
FRAME |
PIECNTR |
SYMBOL |
The coordinate system that you specify
with the YSYS variable affects how the function interprets the value of the
Y or YC variable.
Note: Not all coordinate systems
can be used with all Annotate variables. For any restrictions, see the individual
variables in this section. ![[cautionend]](../../../../common/63294/HTML/default/images/cautend.gif)
Copyright © 2010 by SAS Institute Inc., Cary, NC, USA. All rights reserved.