Enable the SOAP Log

Follow these steps to enable the logging of the SOAP packets that are transmitted and received by the DataFlux Data Management Server.
Note: Enable the SOAP log only temporarily, and only for the purpose of debugging. When debugging is complete, be sure to disable the SOAP log.
  1. Stop the DataFlux Data Management Server.
  2. Create a backup copy of the file install-path\etc\dmserver.log.xml.
    CAUTION:
    An improperly edited dmserver.log.xml file can prevent the start of the DataFlux Data Management Server.
  3. Open the file install-path\etc\dmserver.log.xml.
  4. To remove the comment tags from the configuration information that enables the SOAP log, see the comments in the dmserver.log.xml file. The configuration information also indicates the structure of the SOAP log filename.
  5. Save and close the file dmserver.log.xml.
  6. Restart the DataFlux Data Management Server.
Contact your SAS Technical Support Representative if you need to route SOAP log entries to the main server log file.
Copyright © SAS Institute Inc. All rights reserved.