Problem Note 67761: Parameter values are not displayed when you use the values in a selection-dependent group in SAS® Marketing Automation
 |  |  |  |  |
In SAS Marketing Automation, parameter values are not displayed when you use them in a selection-dependent group. This problem happens when the prompt is two levels down and it is the default selection in the selection-dependent group.
For example, in the stored process that is defined in the image below, the test prompt from the selection group sel2 is not displayed. This issue happens because sel2 is two levels down in the Parameters list, and it is the default selection.
However, if you test the the prompt in SAS® Management console (as shown on the left side of the image), everything works as intended. The issue is evident when you use the stored process in SAS® Customer Intelligence Studio.
To see the prompt, select another value from the drop-down list and then go back to the default value.
Click the Hot Fix tab in this note to access the hot fix for this issue.
Operating System and Release Information
| Product Family | Product | System | Product Release | SAS Release | ||
| Reported | Fixed* | Reported | Fixed* | |||
| SAS System | SAS Marketing Automation | Microsoft® Windows® for x64 | 6.6 | |||
| 64-bit Enabled AIX | 6.6 | |||||
| 64-bit Enabled Solaris | 6.6 | |||||
| Linux for x64 | 6.6 | |||||