SUPPORT / SAMPLES & SAS NOTES
Problem Note 60674: Stress tasks that output SCENTRANS fail when a query uses a subset of cross-classification variables
 |  |  |  |  |
When you perform a task using the SAS® High-Performance Risk procedure that specifies the ScenTrans output data set, you might see the following errors:
ERROR: An OK signal was not received from the HPRisk Engine in determining whether the SCENTRANS data set was successfully written.
ERROR: Journals were not received after query.
ERROR: Journals were not received after query.
These errors might occur when your stress query contains a CROSSCLASSVARS statement that specifies a smaller subset of cross-classification variables than were used to create the cube.
These errors might also occur when you are performing large runs that use the ScenTrans output data set. For more information, see SAS Note 60496: "Larger runs using the ScenTrans output data set fail with errors."
Click the Hot Fix tab in this note to access the hot fix for this issue.
Operating System and Release Information
| Product Family | Product | System | Product Release | SAS Release | ||
| Reported | Fixed* | Reported | Fixed* | |||
| SAS System | SAS High-Performance Risk | 64-bit Enabled AIX | 3.7 | 3.9 | 9.4 TS1M4 | 9.4 TS1M5 |
| 64-bit Enabled Solaris | 3.7 | 3.9 | 9.4 TS1M4 | 9.4 TS1M5 | ||
| Linux for x64 | 3.7 | 3.9 | 9.4 TS1M4 | 9.4 TS1M5 | ||
| Solaris for x64 | 3.7 | 3.9 | 9.4 TS1M4 | 9.4 TS1M5 | ||