In SAS 9.4 TS1M2, you cannot reset the return condition code when you run a SAS Stored Process. The condition code (status code or error code) is assigned the highest value that is returned for all steps in the stored-process request.

In releases earlier than SAS 9.4 TS1M2, you can change the condition code by resetting the &SYSCC macro variable. However, in SAS 9.4 TS1M2, such a change has no effect.

In addition, the STPSRVSET function does not reset the return condition code. For example, in SAS 9.3 and later, the following statement has no effect:

 rc=stpsrvset('program error',0);  

Click the Hot Fix tab in this note to access the hot fix for this issue.

Operating System and Release Information

A fix for this issue for Base SAS 9.4_M3 is available at:

A fix for this issue for Base SAS 9.4_M2 is available at: