The installation of
SAS Data Surveyor for Clickstream Data Mid-Tier 2.2 requires a connection
to the metadata server. When you upgrade to the 2.2 release of SAS
Data Surveyor for Clickstream Data Mid-Tier, the PLATFMLTYES are installed
at the same time if this product was not already on this machine.
If you are upgrading
several SAS products (such as SAS Data Surveyor for Clickstream 2.2
and another SAS product), then the SAS Data Surveyor for Clickstream
Data Mid-Tier should be configured automatically.
However, if SAS Data
Surveyor for Clickstream Data Mid-Tier is the only SAS product that
is being upgraded on a machine, then complete the following steps:
-
Start the SAS Deployment
Wizard by double-clicking on setup.exe in the highest-level directory
of your SAS Software Depot.
By completing the steps
in the SAS Deployment Wizard will upgrade the machine to the 2.2 release
of the SAS Data Surveyor for Clickstream Data Mid-Tier. However, you
need to run the SAS Deployment Wizard a second time to configure your
machine.
-
Run the SAS Deployment
Wizard a second time by double-clicking on setup.exe in the highest-level
directory of your SAS Software Depot.
-
In the Select Deployment
Task step, select
Install SAS software.
-
In the Select Deployment
Type step, select
Perform a Planned Deployment, deselect
Install SAS software, and select
Configure SAS software.
-
Select a valid plan
and machine.
-
In the Select Products
to Configure step, verify that
Data Surveyor for Clickstream
Data Mid-Tier is selected.
-
Complete the remaining
steps in the SAS Deployment Wizard as usual.
When you are finished,
SAS Data Surveyor for Clicksteam Data Mid-Tier is configured on that
machine.