PCHART Statement: ANOM Procedure

Syntax: PCHART Statement

The basic syntax for the PCHART statement is as follows:

  • PCHART response $*$ group-variable;

The general form of this syntax is as follows:

  • PCHART responses $*$ group-variable <(block-variables)><=symbol-variable | ='character'> <options >;

You can use any number of PCHART statements in the ANOM procedure. The components of the PCHART statement are described as follows.

response
responses

identify one or more responses to be analyzed. The specification of response depends on the input data set specified in the PROC ANOM statement.

A response is required. If you specify more than one response, enclose the list in parentheses. For example, the following statements request distinct ANOM p charts for the responses Rejects and Reworks:

proc anom data=Measures;
   pchart (Rejects Reworks)*Sample / groupn=100;
run;

Note that when data are read from a DATA= data set, the GROUPN= option, which specifies group sample sizes, is required.

group-variable

is the variable that identifies groups in the data. The group-variable is required. In the preceding PCHART statement, Sample is the group variable.

block-variables

are optional variables that identify sets of consecutive groups on the chart. The blocks are labeled in a legend, and each block-variable provides one level of labels in the legend.

symbol-variable

is an optional variable whose levels (unique values) determine the symbol marker used to plot proportions. Distinct symbol markers are displayed for points corresponding to the various levels of the symbol-variable. You can specify the symbol markers with SYMBOLn statements.

options

control the analysis, enhance the appearance of the chart, save results in data sets, and so on. The section Summary of Options lists all options by function.