Methods for Estimating the Standard Deviation :: SAS/QC(R) 12.1 User's Guide

Methods for Estimating the Standard Deviation

When control limits are determined from the input data, two methods are available for estimating the process standard deviation $\sigma$ .

Default Method

The default estimate for $\sigma$ is

$\hat{\sigma } = \frac{R_{1}/d_{2}(n_{1})+ \cdots + R_{N}/d_{2}(n_{N})}{N}$

where N is the number of subgroups for which $n_ i \geq 2$ , and is the sample range of the observations $x_{i1}$ , . . . , $x_{in_{i}}$ in the ith subgroup.

A subgroup range $R_{i}$ is included in the calculation only if $n_{i} \geq 2$ . The unbiasing factor is defined so that, if the observations are normally distributed, the expected value of is equal to $d_2(n_ i)\sigma$ . Thus, $\hat{\sigma }$ is the unweighted average of N unbiased estimates of $\sigma$ . This method is described in the American Society for Testing and Materials (1976).

MVLUE Method

If you specify SMETHOD=MVLUE, a minimum variance linear unbiased estimate (MVLUE) is computed for $\sigma$ . Refer to Burr (1969, 1976) and Nelson (1989, 1994). The MVLUE is a weighted average of N unbiased estimates of $\sigma$ of the form , and it is computed as

$\hat{\sigma } = \frac{f_{1}R_{1}/d_{2}(n_{1})+ \cdots + f_{N}R_{N}/d_{2}(n_{N})}{f_1 + \cdots + f_ N}$

where

$f_ i = \frac{[d_2(n_ i)]^{2}}{[d_3(n_ i)]^{2}}$

A subgroup range is included in the calculation only if $n_ i \geq 2$ , and N is the number of subgroups for which $n_{i} \ geq 2$ . The MVLUE assigns greater weight to estimates of $\sigma$ from subgroups with larger sample sizes, and it is intended for situations where the subgroup sample sizes vary. If the subgroup sample sizes are constant, the MVLUE reduces to the default estimate.

See Example 17.16 for illustrations of the default and MVLUE methods.

MRCHART Statement: SHEWHART Procedure

Methods for Estimating the Standard Deviation

Default Method

MVLUE Method