INSET Statement: MACONTROL Procedure

Syntax: INSET Statement

The syntax for the INSET statement is as follows:

INSET keyword-list </ options> ;

You can use any number of INSET statements in the MACONTROL procedure. Each INSET statement produces a separate inset and must follow an EWMACHART or MACHART statement. The inset appears on every panel (page) produced by the last chart statement preceding it.

Keywords specify the statistics to be displayed in an inset; options control the inset’s location and appearance. A complete description of the INSET statement syntax is given in the section Syntax: INSET and INSET2 Statements of Chapter 15, The SHEWHART Procedure. The INSET statement options are identical in the MACONTROL and SHEWHART procedures, but the available keywords are different. The options are listed in Table 15.87. The keywords available with the MACONTROL procedure are listed in Table 9.14 to Table 9.17.

Table 9.14 Summary Statistics
Keyword	Description
MEAN	estimated or specified process mean
N	nominal subgroup size
NMIN	minimum subgroup size
NMAX	maximum subgroup size
NOUT	number of subgroups outside control limits
NLOW	number of subgroups below lower control limit
NHIGH	number of subgroups above upper control limit
STDDEV	estimated or specified process standard deviation
DATA=	arbitrary values from SAS-data-set

Table 9.15 Parameter for Uniformly Weighted Moving Average Charts
Keyword	Description
SPAN	number of terms used to calculate moving average

Table 9.16 Parameter for Exponentially Weighted Moving Average Charts
Keyword	Description
WEIGHT	weight assigned to most recent subgroup mean in computation of the EWMA

You can use the keywords in Table 9.17 only when producing ODS Graphics output. The labels for the statistics use Greek letters.

Table 9.17 Keywords Specific to ODS Graphics Output
Keyword	Description
UMU	estimated or specified process mean
USIGMA	estimated or specified process standard deviation