The OPTNET Procedure

Example 2.5 Minimum Spanning Tree for Computer Network Topology

Consider the problem of designing a small network of computers in an office. In designing the network, the goal is to make sure that each machine in the office can reach every other machine. To accomplish this goal, Ethernet lines must be constructed and run between the machines. The construction costs for each possible link are based approximately on distance and are shown in Output 2.5.1. Besides distance, the costs also reflect some restrictions due to physical boundaries. To connect all the machines in the office at minimal cost, you need to find a minimum spanning tree on the network of possible links.

Output 2.5.1: Potential Office Computer Network


Define the link data set as follows:

data LinkSetInCompNet;
   input from $ to $ weight @@;
   datalines;
A B 1.0  A C 1.0  A D 1.5  B C 2.0  B D 4.0
B E 3.0  C D 3.0  C F 3.0  C H 4.0  D E 1.5
D F 3.0  D G 4.0  E F 1.0  E G 1.0  F G 2.0
F H 4.0  H I 1.0  I J 1.0
;

The following statements find a minimum spanning tree:

proc optnet
   data_links = LinkSetInCompNet;
   minspantree
      out     = MinSpanTree;
run;

Output 2.5.3 shows the resulting data set MinSpanTree, which is displayed graphically in Output 2.5.2 with the minimal cost links shown in green.

Output 2.5.2: Minimum Spanning Tree for Office Computer Network


Output 2.5.3: Minimum Spanning Tree of a Computer Network Topology

from to weight
H I 1.0
E G 1.0
E F 1.0
A B 1.0
A C 1.0
I J 1.0
D E 1.5
A D 1.5
C H 4.0
    13.0