Previous Page | Next Page

Data Smoothing: Thin-Plate Spline

Output Variables Tab

You can use the Output Variables tab (Figure 19.7) to add analysis variables to the data table. If you request a plot that uses one of the output variables, then that variable is automatically created even if you did not explicitly select the variable on the Output Variables tab.

The following list describes each output variable and indicates how it is named. represents the name of the response variable.

Predicted values


adds predicted values. The variable is named TPSplP_.

Confidence limits for means


adds 95% confidence limits for the expected value (mean). The variables are named TPSplLclm_ and TPSplUclm_.

Raw residuals


adds residuals, which are calculated as observed values minus predicted values. The variable is named TPSplR_.

Figure 19.7 The Output Variables Tab
The Output Variables Tab

Previous Page | Next Page | Top of Page