Exploring Data in One Dimension

Example

In this section you create a bar chart of the category variable of the Hurricanes data set. The category variable gives the Saffir-Simpson wind intensity category for each observation.

The category variable is encoded according to the value of wind_kts, as shown in Table 5.1.

Table 5.1: The Saffir-Simpson Intensity Scale

Category	Description	Wind Speed (knots)
TD	Tropical Depression	22 - 33
TS	Tropical Storm	34 - 63
Cat1	Category 1 Hurricane	64 - 82
Cat2	Category 2 Hurricane	83 - 95
Cat3	Category 3 Hurricane	96 - 113
Cat4	Category 4 Hurricane	114 - 134
Cat5	Category 5 Hurricane	135 or greater

The category variable also has missing values, representing weak intensities (wind speed less than 22 knots).

Open the Hurricanes data set.

Select Graph Bar Chart from the main menu, as shown in Figure 5.1.

Figure 5.1: Selecting a Bar Chart

A dialog box appears as in Figure 5.2.

Select the category variable, and click Set X.

Click OK.

Note: The bar chart also supports an optional frequency variable.

Figure 5.2: The Bar Chart Dialog Box

A bar chart appears (Figure 5.3), showing the unique values of the category variable. The chart shows that most of the observations in the data set are for tropical storms and tropical depressions. There are relatively few category 5 hurricanes.

Figure 5.3: A Bar Chart

The category variable has missing values. The set of missing values are grouped together and represented by a bar labeled with the symbol.

You can click on a bar to select the observations contained in that bar. You can click while holding down the CTRL key to select observations in multiple bars. You can drag out a selection rectangle to select observations in contiguous bars.

You can create bar charts of any nominal variable, numeric or character.

Previous Page

|

Next Page

|

Top of Page