MAPSSAS= System Option
Specifies the location of the SAS library that contains SAS/GRAPH non-digital map data
sets. The libref MAPSSAS is assigned using the option value specified
by the MAPSSAS system option.
| Valid in: |
Configuration file and SAS invocation |
| Category: |
Graphics: Driver settings |
| PROC OPTIONS GROUP= |
GRAPHICS |
| Restriction: |
This option cannot be saved to the SAS registry by using
the OPTSAVE procedure. Nor can it be saved by using the DMOPTSAVE
command in the SAS windowing environment.
|
| Note: |
This option can be restricted by a site administrator. For more information,
see Restricted Options in SAS System Options: Reference. |
Syntax
Syntax Description
On the command line or in a configuration file, the syntax
is specific to your operating environment. For more information, see
the SAS documentation for your operating environment.
- location-of-maps
-
specifies either a
physical path, an environment variable, or the MAPSSAS libref to locate
the SAS non-digital vector map data sets to use with SAS/GRAPH. The option value can consist of
up to 2048 characters. Upper or lower case characters are accepted
as entered. Though not required, if you specify start and end quotes
or parentheses, these are accepted and retained as part of the option’s
value.
Default:None
Note:The configuration file at installation time sets the
MAPSSAS= and the MAPS= option values to the same physical name (path).
The MAPSSAS= option value should not be reassigned.