Graphics Options and Device Parameters Dictionary |
Specifies the increment of paper that is ejected when a graph
is completed.
Used in: |
GOPTIONS statement; GDEVICE procedure; GDEVICE
Detail window
|
Default: |
PAPERFEED=0.0 IN
|
Restriction: |
device-dependent; not supported by Java
or ActiveX
|
PAPERFEED=feed-increment <IN |
CM>
|
-
feed-increment
<IN | CM>
-
must be a nonnegative number and can be
followed by a unit specification, either IN for inches (default) or CM for
centimeters.
PAPERFEED does not control the total length
of the ejection. If you specify PAPERFEED=1, the driver ejects paper in 1
inch increments until the total amount of paper ejected is at least half an
inch greater than the size of the graph last printed. If you specify PAPERFEED=8.5
IN, the paper is ejected in increments of 8.5 inches, measuring from the origin
of the first graph.
PAPERFEED is provided mainly for plotters that use fanfold
or roll paper. If you are using fanfold paper, specify a value for PAPERFEED
that is equal to the distance between the perforations.
Copyright © 2010 by SAS Institute Inc., Cary, NC, USA. All rights reserved.