The following statements transpose part of the interleaved-form output data set FOREOUT, produced by PROC FORECAST in a previous example, to a standard form time series data set. To reduce the volume of output produced by the example, a WHERE statement is used to subset the input data set.

Observations with _TYPE_=ACTUAL are stored in the new variable ACTUAL; observations with _TYPE_=FORECAST are stored in the new variable FORECAST; and so forth. Note that the method used in this example works only for a single variable.

title "Original Data Set";
proc print data=foreout(obs=10);
   where date > '1may1991'd & date < '1oct1991'd;
run;

proc transpose data=foreout out=trans(drop=_name_);
   var cpi;
   id _type_;
   by date;
   where date > '1may1991'd & date < '1oct1991'd;
run;

title "Transposed Data Set";
proc print data=trans(obs=10);
run;

The TRANSPOSE procedure adds the variables _NAME_ and _LABEL_ to the output data set. These variables contain the names and labels of the variables that were transposed. In this example, there is only one transposed variable, so _NAME_ has the value CPI for all observations. Thus, _NAME_ and _LABEL_ are of no interest and are dropped from the output data set by using the DROP= data set option. (If none of the variables transposed have a label, PROC TRANSPOSE does not output the _LABEL_ variable and the DROP=_LABEL_ option produces a warning message. You can ignore this message, or you can prevent the message by omitting _LABEL_ from the DROP= list.)

The original and transposed data sets are shown in Figure 3.17 and Figure 3.18. (The observation numbers shown for the original data set reflect the operation of the WHERE statement.)

The following statements transpose the variable CPI in the CPICITY data set shown in a previous example from time series cross-sectional form to a standard form time series data set. (Only a subset of the data shown in the previous example is used here.) Note that the method shown in this example works only for a single variable.

title "Original Data Set";
proc print data=cpicity;
run;

proc sort data=cpicity out=temp;
   by date city;
run;

proc transpose data=temp out=citycpi(drop=_name_);
   var cpi;
   id city;
   by date;
run;

title "Transposed Data Set";
proc print data=citycpi;
run;

The names of the variables in the transposed data sets are taken from the city names in the ID variable CITY. The original and the transposed data sets are shown in Figure 3.19 and Figure 3.20.

The following statements transpose the CITYCPI data set back to the original form of the CPICITY data set. The variable _NAME_ is added to the data set to tell PROC TRANSPOSE the name of the variable in which to store the observations in the transposed data set. (If the (DROP=_NAME_ _LABEL_) option were omitted from the first PROC TRANSPOSE step, this would not be necessary. PROC TRANSPOSE assumes ID _NAME_ by default.)

The NAME=CITY option in the PROC TRANSPOSE statement causes PROC TRANSPOSE to store the names of the transposed variables in the variable CITY. Because PROC TRANSPOSE recodes the values of the CITY variable to create valid SAS variable names in the transposed data set, the values of the variable CITY in the retransposed data set are not the same as in the original. The retransposed data set is shown in Figure 3.21.

data temp;
   set citycpi;
   _name_ = 'CPI';
run;

proc transpose data=temp out=retrans name=city;
   by date;
run;

proc sort data=retrans;
   by city date;
run;

title "Retransposed Data Set";
proc print data=retrans;
run;