Previous Page

|

Next Page

Defining Variables

Defining the variables for a fractional factorial design is the same as those for a full factorial design, which are described in the section "Creating a Full Factorial Design". Follow these steps:

1. Select File Create New Design Two-level from the ADX desktop to open the main design window.
2. Click Define Variables.
3. The Define Variables window will appear. Click Add and select 6 as the number of rows to add. Recall that the low level is set to -1 and the high level is set to 1. Enter the factor names as shown in the illustration.
   
   

   
   
   

4. Click the Response tab to enter response variables.
5. Change the response name to SHRINK and the label to Observed Shrinkage.
6. Click OK.
7. ADX asks if you want to save the changes. Click Yes.