Chapter Contents

Previous

Next
Window Directory

Message Window

Message Window

[IMAGE]

DESCRIPTION
The Message window displays error messages. If an invalid command is specified in either the Command or Log window, descriptive error messages are sent to the Log window. Error messages that are associated with all other windows are displayed in a Message window that is similar to the one shown above. The Message window is automatically opened by the debugger. After viewing the message, you can press ENTER or any PF key to close the window. Pressing a PF key that contains an invalid command also results in the display of a Message window that contains an error message.

The Message window is used to display error messages that do not accept input as opposed to the Popup window, which is used to request correction of invalid input.

ADDITIONAL DISCUSSION
Factors Affecting Your Full-Screen Session

SEE ALSO
Popup Window


Chapter Contents

Previous

Next

Top of Page

Copyright © 2001 by SAS Institute Inc., Cary, NC, USA. All rights reserved.