Consider a dichotomous response variable with outcomes event and nonevent. Let a dichotomous risk factor variable X take the value 1 if the risk factor is present and 0 if the risk factor is absent. According to the logistic model, the log odds function, , is given by
The odds ratio is defined as the ratio of the odds for those with the risk factor (X = 1) to the odds for those without the risk factor (X = 0). The log of the odds ratio is given by
The parameter, , associated with X represents the change in the log odds from X = 0 to X = 1. So the odds ratio is obtained by simply exponentiating the value of the parameter associated with the risk factor. The odds ratio indicates how the odds of event change as you change X from 0 to 1. For instance, means that the odds of an event when X = 1 are twice the odds of an event when X = 0.
Suppose the values of the dichotomous risk factor are coded as constants a and b instead of 0 and 1. The odds when become , and the odds when become . The odds ratio corresponding to an increase in X from a to b is
Note that for any a and b such that . So the odds ratio can be interpreted as the change in the odds for any increase of one unit in the corresponding risk factor. However, the change in odds for some amount other than one unit is often of greater interest. For example, a change of one pound in body weight might be too small to be considered important, while a change of 10 pounds might be more meaningful. The odds ratio for a change in X from a to b is estimated by raising the odds ratio estimate for a unit change in X to the power of , as shown previously.
For a polytomous risk factor, the computation of odds ratios depends on how the risk factor is parameterized. For illustration,
suppose that Race
is a risk factor with four categories: White, Black, Hispanic, and Other.
For the effect parameterization scheme (PARAM=EFFECT) with White as the reference group, the design variables for Race
are as follows.
Design Variables 


Race 



Black 
1 
0 
0 
Hispanic 
0 
1 
0 
Other 
0 
0 
1 
White 
–1 
–1 
–1 
The log odds for Black is






The log odds for White is






Therefore, the log odds ratio of Black versus White becomes






For the reference cell parameterization scheme (PARAM=REF) with White as the reference cell, the design variables for race are as follows.
Design Variables 


Race 



Black 
1 
0 
0 
Hispanic 
0 
1 
0 
Other 
0 
0 
1 
White 
0 
0 
0 
The log odds ratio of Black versus White is given by












For the GLM parameterization scheme (PARAM=GLM), the design variables are as follows.
Design Variables 


Race 




Black 
1 
0 
0 
0 
Hispanic 
0 
1 
0 
0 
Other 
0 
0 
1 
0 
White 
0 
0 
0 
1 
The log odds ratio of Black versus White is












Consider the hypothetical example of heart disease among race in Hosmer and Lemeshow (2000, p. 51). The entries in the following contingency table represent counts.
Race 


Disease Status 
White 
Black 
Hispanic 
Other 
Present 
5 
20 
15 
10 
Absent 
20 
10 
10 
10 
The computation of odds ratio of Black versus White for various parameterization schemes is shown in Table 91.9.
Table 91.9: Odds Ratio of Heart Disease Comparing Black to White
Parameter Estimates 


PARAM= 




Odds Ratio Estimates 
EFFECT 
0.7651 
0.4774 
0.0719 


REF 
2.0794 
1.7917 
1.3863 


GLM 
2.0794 
1.7917 
1.3863 
0.0000 

Since the log odds ratio () is a linear function of the parameters, the Wald confidence interval for can be derived from the parameter estimates and the estimated covariance matrix. Confidence intervals for the odds ratios are obtained by exponentiating the corresponding confidence intervals for the log odd ratios. In the displayed output of PROC SURVEYLOGISTIC, the “Odds Ratio Estimates” table contains the odds ratio estimates and the corresponding 95% Wald confidence intervals computed by using the covariance matrix in the section Variance Estimation. For continuous explanatory variables, these odds ratios correspond to a unit increase in the risk factors.
To customize odds ratios for specific units of change for a continuous risk factor, you can use the UNITS statement to specify a list of relevant units for each explanatory variable in the model. Estimates of these customized odds ratios are given in a separate table. Let be a confidence interval for . The corresponding lower and upper confidence limits for the customized odds ratio are and , respectively, (for ); or and , respectively, (for c < 0). You use the CLODDS option in the MODEL statement to request confidence intervals for the odds ratios.
For a generalized logit model, odds ratios are computed similarly, except D odds ratios are computed for each effect, corresponding to the D logits in the model.