In the preceding example, you assumed that the population standard deviations were equal. If you believe that the population standard deviations are not equal, use the same two-sample t test analysis as with the preceding example, but change the test option and enter group standard deviations.

You can use the previous example to demonstrate this test. If the project is not already open, open it by selecting

→ on the menu bar, and then selecting the project that you have been using.Make a copy of the project by selecting ** Experimental blood pressure drug with two groups for unequal variances**. Click .

The copy of the project is opened, and the current project is closed.

Click the **Standard Deviation** tab and enter the group standard deviations of 12 and 15 on a single row, as shown in Figure 72.47.

Table 72.3 contains the values of the input parameters for the example.

Table 72.3: Summary of Input Parameters

Parameter |
Value |
---|---|

Distribution |
Normal |

Hypothesis |
One-sided test |

Test |
Satterthwaite t test |

Alpha |
0.05 |

Means form |
Group means |

Means |
132, 120 |

Standard deviation |
12, 15 |

Sample size form |
Sample size per group |

Sample size |
20, 25, 30 |

Click

to run the analysis.The power for a sample size per group of 25 is 0.924, as shown in Figure 72.48. Notice that the actual alpha is 0.0499. This is because the Satterthwaite t test is (slightly) biased.

If you modified the previous example, when you select the **Narratives** tab, the following message is displayed:

`Previously selected narratives have been cleared because one or more input parameter values have changed.`

In the previous analysis, you created narratives for two scenarios. Because this analysis uses group standard deviations, those selected narratives were cleared. The message would also have appeared if you had changed the number of scenarios.

Use the narrative selector table to create other narratives.