You can use the Output Variables tab to add analysis variables to the data table. (See Figure 30.8.) If you request a plot that uses one of the output variables, then that variable is automatically created even if you did not explicitly select the variable on the Output Variables tab.
The following list describes each output variable and indicates how the output variable is named. 
represents the name of the classification variable.
- Posterior probabilities of group membership
-
adds variables named
DiscProb_, where
is the name of an X variable.
- Predicted groups
-
adds a variable named
DiscPred_that contains the name of the group to which each observation is assigned.
If a classification fit plot is requested on the Plots tab, then a variable named DiscLogProb_
is created, as described in the section The Plots Tab.
