Monitor the Performance of a Champion Model

In this tutorial you use the Edit Performance Definition wizard to generate SAS code. You then execute the generated code.
To edit the performance definition:
  1. Select the Performance page.
  2. Click Edit definition and select the champion model Tree 1. Click Next.
    Edit Performance Definition - Select Model
  3. Select a SAS Application Server (for example, the default is SASApp).
  4. Click All to select all output variables for stability analysis.
  5. Click All to select all input variables for characteristic analysis.
    Edit Performance Model - Select Server and Variables
    Click Next.
  6. Select Standard configuration as the data processing method and select Run model score code to run the score code in the performance monitor job.
  7. Specify the data source information.
    1. Select Static data sources.
    2. Click Add.
      Note: The data table whose collection date is the earliest is set as the baseline performance data table.
    3. Click the empty cell in the Data Source column.
    4. Click Browse and select the HMEQ_PERF_Q1 performance data source from the QSTutorial library. Click OK.
    5. Click the empty cell in the Collection Date column and click Date Calendar. Select the date of March 31, 2014. The date can be any date in the time period when the performance data was collected.
    6. Enter the label Q1 in the Report Label column. The report label represents the time point of the performance data source. Because the report label appears in the performance charts, use a label that has not been used for another time period, is short, and is understandable.
      Note: If you duplicate report labels, the results in the previous performance results are overwritten.
    7. (Optional) Select a data source and click Validate data source to verify that the selected input variables and target variable are included in the performance data source.
    8. (Optional) Repeat the above steps to add the following performance data sources from the QSTutorial library to the performance definition.
      Data Source
      Collection Date
      Report Label
      HMEQ_PERF_Q2
      June 30, 2014
      Q2
      HMEQ_PERF_Q3
      September 30, 2014
      Q3
      HMEQ_PERF_Q4
      December 31, 2014
      Q4
      Edit Performance Definition - Set Processing and Performance Options
    9. (Optional) To delete a data source from the performance definition, select the data source and click Delete.
  8. Click Next.
    Note: When prompted to replace the existing performance data, click Yes.
  9. (Optional) Either specify values for the alert and warning conditions or accept the defaults. Click Next.
  10. (Optional) To send the results by email, click Add. A new row is added to the table.
    1. Enter an email address.
    2. Select either Yes or No if you want an alert or warning to be sent by email when alert or warning thresholds have been exceeded.
    3. Select either Yes or No if you want a completion notice with the job status to be sent by email every time the report runs.
    Set Alerts and Notifications
  11. Click Save.
  12. Click Execute.
  13. After the performance monitoring has been completed, a confirmation message appears. Click Close.
  14. Click the Results tab to view the performance results.
    Note: You can check the status of a job by clicking Refresh in the Job History tab. A new record appears after the job has completed.

See Also

Edit and Execute a Performance Definition
Copyright © SAS Institute Inc. All Rights Reserved.
Last updated: February 22, 2017