Dynamic Lift Reports

About Dynamic Lift Reports

The Dynamic Lift report enables you to view a model's lift at a given point in time or to compare the lift performance of several models on one chart. The Dynamic Lift report creates the following charts:
  • Lift
  • Cumulative Lift
  • Percent Response
  • Cumulative Percent Response
  • Captured Response
  • Cumulative Captured Response
A Dynamic Lift report can be created only for classification models with a binary target.
The charts that are created for a Dynamic Lift report are also created in the Monitoring Report, which creates multiple types of model comparison reports. Before you can create a Dynamic Lift report, certain project and model property settings must be set.
For models that are created with PMML 4.2 and later, the Valid variable name option in SAS Management Console must be set to Yes by a SAS Decision Manager administrator. In addition, the PMML variable names cannot be more than 20 characters. For more information, see SAS Decision Manager: Administrator’s Guide.

Verify Project and Model Property Settings

Verify Project Properties

Select the project name and verify that the following project properties are set:
Training target variable
Specifies the name of the target variable that was used to train the model. The model must have the same training target variable as the project.
Target event value
Specifies the value for the desired target variable event or state. For example, if a model predicts when RESPONSE=YES, then the target event value is YES.
Output event probability variable
Specifies the name of the output event’s probability variable.

Verify Model Properties

For each model in the Dynamic Lift report, open the model and verify the following properties on the Model Properties page:
Properties
Property
Description
Target variable
Specifies the name of the target variable. For example, if a model predicts when RESPONSE=YES, then the target variable is RESPONSE.
Score code type
Specifies whether the score code runs using a DATA step fragment or SAS code that is not a DATA step fragment.
Note: Dynamic Lift reports are not applicable to models whose Score code type property has a value of PMML. For PMML 4.2 and later, a Dynamic Lift report can be created for a PMML model whose Score code type is DATA step.

Create a Dynamic Lift Report

After ensuring that the appropriate project and model properties have been set, create the report.
To create a Dynamic Lift report:
  1. Click New report and select Dynamic Lift. The New Report window appears.
    Dynamic Lift Report
  2. Enter a name and description if you do not want to use the default values.
  3. Select an output type. The default is PDF.
  4. Select a style for the report. When the SAS default option is selected, the default style and themes are used in generating the report. For example, the SAS default style for the HTML output type is HTMLBLUE.
  5. From the list, select the models that you want to include in the report.
  6. Specify the Control group response rate. The control group response rate calculates the adjusted lift values for a model. If the control group response rate is not specified, the default response rate in the test table is used to calculate the adjusted lift values.
  7. Specify the Prior probability. The prior probability is the proportion of event observations to the total observations in the whole population. In this case, the whole population is the entire train table. Specify a value for the prior probability to be used as the true event proportion when assessment values are computed for the lift of a model.
  8. Accept the default value for Input table or click Browse to navigate to the appropriate folder to select an input table. Click OK.
  9. Click Run. The report is generated and appears in the default viewer for the selected output type.

See Also

Last updated: February 22, 2017