Providing software solutions since 1976

• Log in
• Create profile
• Welcome
  [Log out]
• Edit profile

• Print  |
• Feedback  |
• Share

  • E-mail

  
  
  

  E-mail This Page

  Your Name:*
  Your E-mail:*
  Recipient E-mail:*
  Send a copy to me
  Personal Message:
  
  

  * indicates a required field

ODS works with DATA step in two ways: FILE PRINT ODS can be used when
creating tabular output and FILE PRINT can be used when creating
free-form output.

When FILE PRINT is used to create non-listing output, ODS ESCAPECHAR=
and inline formatting commands can be used on a PUT statement to create
style changes 'on the fly'.  With FILE PRINT, the entire contents of a
PUT statement create one cell in the output table.

With PDF, the output table is centered by default.  Each line is
centered after being padded with blanks to the full LINESIZE, even if
only a fraction of those characters are actually printed.
Unfortunately, these blanks are added while the inline commands are
still in place.  When the inline formatting is stripped off and turned
into formatting, the output is much shorter than the other lines and,
thus, gets centered differently that the other lines.  As a work around,
one can specify

OPTION NOCENTER;

The sample program below illustrates the issue. Run with OPTIONS
CENTER specified to see the unexpected alignment.  Run again with
OPTIONS NOCENTER to see the desired alignment.

 OPTIONS center;
*OPTIONS nocenter;

  ODS pdf file='temp.pdf';
  ODS escapechar='^';

  data _null_;
    file print;
    put '++++5++++0';
    put 'TEST'+1 '^S={font_style=italic font_weight=bold}'
        'the PDF output destination';
  run;
  ODS pdf close;



See also FAQ 4209 ( #24227 ).  For
alignment issues when using FILE PRINT ODS see  #005486 .

Operating System and Release Information