Chapter Contents

Previous

Next

Introduction

The SAS/C Debugger uses your PROFILE and a configuration file to execute debugger commands and determine your initial configuration upon entry to the debugger. This chapter explains how to do the following:

• set up a PROFILE containing debugger commands that are issued at initial entry to your program

• set up and specify a configuration file that controls your initial debugger configuration

• issue the exec command from your PROFILE to execute a CLIST or an EXEC when the debugger is invoked

• use the exececho keyword with the auto command in order to echo lines from an EXEC or CLIST

• use the dbinput command in order to input data from the terminal to an EXEC or CLIST

• use the dblog command in order to output information from an EXEC or CLIST to the Log window or session log.

Chapter Contents

Previous

Next

Top of Page

Copyright © 2001 by SAS Institute Inc., Cary, NC, USA. All rights reserved.