Previous Page | Next Page

The HPMIXED Procedure

TEST Statement
TEST fixed-effects </ options> ;

The TEST statement performs a hypothesis test on the fixed effects. You can specify multiple effects in one TEST statement or in multiple TEST statements, and all TEST statements must appear after the MODEL statement.

You can specify the following options in the TEST statement after a slash (/).

HTYPE=value-list

indicates the type of hypothesis test to perform on the specified effects. Valid entries for values in the value-list are 3, corresponding to a Type III test. The default value is 3. The ODS table name is "Tests3" for the Type III test.

E

requests that matrix coefficients associated with test types be displayed for specified effects.

E3 | EIII

requests that Type III matrix coefficients be displayed if a Type III test is performed.

CHISQ

requests that tests be performed in addition to any F tests. A statistic equals its corresponding F statistic times the associate numerator degree of freedom, and this same degree of freedom is used to compute the p-value for the test. This p-value will always be less than that for the F test, because it effectively corresponds to an F test with infinite denominator degrees of freedom.


Note: This procedure is experimental.

Previous Page | Next Page | Top of Page