Templates

The Bucket block is used to extract and store entity attribute values from entities that enter the block. Attributes to be extracted from the entity are identified in the Bucket block’s Attributes Table. When an entity enters the block, entity attribute values are retrieved from the entity and stored in a data model object during the simulation run. The age of the entity is calculated and pushed to the bucket’s OutLatestAge port.

The data model object can be accessed through the block’s OutData port. Display blocks, such as the Histogram block, are often connected to a Bucket block’s OutData port to visualize the data. Any block using a data model is automatically notified when the data in the data model is modified.

The user identifies attributes to be extracted from the entity using one of the attribute collecting options described in the Dialog Controls section below.

The user can limit the number of observations stored in a Bucket block through its Capacity control. If the capacity is exceeded, a warning will be logged and observations will be overwritten.

The Bucket block provides the capability of saving values it extracts to a SAS data set or JMP table. Saving options are available on the Save Dialog.

When a true Boolean value arrives at the InClearData port, it will be used as a signal to clear all the data collected by the Bucket block up to that time during the simulation execution. If the InClearData port receives a false value, the signal will be ignored and data will not be cleared.

Specify the attributes to be extracted from the incoming entity.

The Bucket block provides two options for collecting entity attributes. With the Collect Selected Entity Attributes option selected, the associated attribute table and editing buttons are enabled. The user identifies attributes to be extracted from the entity by selecting the Add button beside the attribute table. This results in a new attribute entry (with a default name) being added to the Attributes Table. The Name and Type of the attribute can be edited directly in the table. The attribute names listed in the Bucket block’s Attributes Table must be unique. The attribute type can be changed through a drop-down box on the Type table cell. Attributes can be deleted from the Attributes Table by selecting the attribute row in the table and then selecting the Remove button. Selecting the Apply button causes all entries in the Attributes Table to be pushed to the Bucket block.

When the Collect All Entity Attributes option is selected, all attributes (except the internal entity ID) will be extracted from the incoming entities.