Running the Model

Figure 2.3 shows the Experiment window for this model. A single experimental design point, called point1, has the number of replications set to 1 and the length of the simulation set to 540 minutes (one banking day).

Figure 2.3: M/M/1 Queueing Model: One Design Point

M/M/1 Queueing Model: One Design Point


To display the simulation clock, select RunShowSimulation Clock from the Simulation Studio menu. To turn on the animation, click the Animation button An M/M/1 Queueing Model . To run this model, click the Start button An M/M/1 Queueing Model . To pause the model, click the Pause button An M/M/1 Queueing Model . To restart the model, click the Start button again. When the model finishes running, only the Reset button An M/M/1 Queueing Model is active. You must click the Reset button before you make changes to the experiment window or rerun the model.