Modifying Arrow Heads

To modify the characteristics of the arrow heads in your diagram, select View Ishikawa Settings Arrows…. This opens the following dialog:

Figure 8.74: Arrows Dialog

 Arrows Dialog


The dialog controls the characteristics of all arrow heads. Arrow heads cannot be modified individually.

Arrow heads can be tapered, flush, or empty. Use the sliders labeled Length and Width to control the length and width of the arrow heads. Move the sliders to the right to increase the length/width of the arrow head and to the left to decrease the length/width.

Removing arrow heads increases the readability of a highly detailed diagram. Use the Display slider to control the level at which arrow heads are displayed. Move the slider to the extreme left to remove all the arrow heads and to the extreme right to display all the arrow heads. Use the intermediate settings to select a threshold level of detail, above which arrow heads are not displayed. By default, arrow heads are displayed for all levels.

Select OKto close the window. To cancel the changes, select Cancel.