The CCHART statement creates charts for the numbers of nonconformities (defects) in subgroup samples.

You can use options in the CCHART statement to

• specify the number of inspection units per subgroup. Typically (but not necessarily), each subgroup consists of a single unit.

• compute control limits from the data based on a multiple of the standard error of the counts or as probability limits

• tabulate subgroup summary statistics and control limits

• save control limits in an output data set

• save subgroup summary statistics in an output data set

• read preestablished control limits from a data set

• apply tests for special causes (also known as runs tests and Western Electric rules)

• specify a known (standard) value for the average number of nonconformities per inspection unit

• display distinct sets of control limits for data from successive time phases

• add block legends and symbol markers to reveal stratification in process data

• superimpose stars at points to represent related multivariate factors

• clip extreme points to make the chart more readable

• display vertical and horizontal reference lines

• control axis values and labels

• control the layout and appearance of the chart

You have three alternatives for producing charts with the CCHART statement:

• Traditional graphics are produced by default.

• ODS Graphics output is produced when you specify the ODS GRAPHICS statement prior to the PROC SHEWHART statement.

• Legacy line printer charts are produced when you specify the LINEPRINTER option in the PROC SHEWHART statement.

See Chapter 3, SAS/QC Graphics, for more information about producing these different kinds of graphs.