Interval Target Variable Report
About Interval Target Variable Reports
The Interval Target
Variable report creates two plots for you to view the actual versus
predicted values for a model and the actual versus residual values
for a model. The Interval Target Variable report can be created only
for prediction models. Before you can create an Interval Target Variable
report, certain project and model property settings must be set.
Verify Project and Model Properties
Before you can run an
Interval Target Variable report, you must set the following project
properties:
Default test table
Specifies a test table
that is registered in the SAS Metadata Repository. You can view the
table in the Data category view. The test table must contain the target
variable, as well as values for the variables that are defined by
the project input variables.
Training target variable
Specifies the name
of the target variable that was used to train the model. The model
must have the same training target variable as the project.
Output prediction variable
Specifies the name
of the output prediction variable.
To verify the model
mapping, select and open the model from the Models page.
Select Model Properties 
Variables to verify that the
model variables are mapped to the project variables. If the variable
names are the same, you do not need to map the variables. If they
are not mapped, for each project variable, select the project variable
and select a variable name.
Variables to verify that the
model variables are mapped to the project variables. If the variable
names are the same, you do not need to map the variables. If they
are not mapped, for each project variable, select the project variable
and select a variable name.
Create an Interval Target Variable Report
Copyright © SAS Institute Inc. All rights reserved.