You can use the Output Variables tab to add analysis variables to the data table. (See Figure 29.13.) If you request a plot that uses one of the output variables, then that variable is automatically created even if you did not explicitly select the variable on the Output Variables tab.
The following list describes each output variable added to the data table and indicates how the output variable is named. represents the name of the classification variable.
adds variables named CDAProb_
, where is the name of an X variable.
adds a variable named CDAPred_
that contains the name of the group to which each observation is assigned.
adds variables named CDA_1
through CDA_
, where is the number of canonical components.
If a classification fit plot is requested on the Plots tab, then a variable named CDALogProb_
is created, as described in the section The Plots Tab.