This section describes the Polygons tab associated with a polygon plot. To access the polygon plot properties, right-click near the center of a plot, and select Plot Area Properties from the pop-up menu.

The Polygons tab controls attributes of the polygon plot. The Polygons tab is shown in Figure 6.22.

The Polygons tab contains the following UI controls:

Close polygons

specifies whether a line segment is drawn from the last observation in each region to the first observation in that region.

Show outline

specifies whether the outline of a region is displayed.

Show fill

specifies whether the interior of a region is displayed.

For a discussion of the Observations tab, see the section Scatter Plot Properties. For a discussion of the remaining tabs, see Chapter 9, General Plot Properties.