PIECNTR Function

Sets new center and radius values for later use by the PIEXY function but does not draw an arc.
Updates: XLAST, YLAST

Syntax

FUNCTION='PIECNTR';

Associated Variables

GROUP=group-value
MIDPOINT=midpoint-value
SUBGROUP=subgroup-value
specify coordinates for HBAR and VBAR charts from the GCHART procedure. Use these variables only with the data coordinate systems 1, 2, 7, and 8.
HSYS='coordinate-system'
specifies the coordinate system for the SIZE variable. See HSYS Variable for an explanation of coordinate-system.
SIZE=radius
specifies the new radius of the pie slice. The new radius is used by a subsequent PIEXY function. The HSYS variable determines the SIZE variable units.
WHEN='B' | 'A'
specifies when to draw the pie slice in relation to other procedure output. See WHEN Variable.
X=horizontal-coordinate
Y=vertical-coordinate
Z=depth-coordinate (PROC G3D only)
XC='character-type-horizontal-coordinate'
YC='character-type-vertical-coordinate'
define the center and radius of the slice. All slices are referenced from that center. Use the Z variable only with the G3D procedure.
XSYS='coordinate-system'
specifies the coordinate system for the X or XC variable. Use the XC variable only with XSYS='2'. See XSYS Variable for an explanation of coordinate-system.
YSYS='coordinate-system'
specifies the coordinate system for the Y or YC variable. Use the YC variable only with YSYS='2'. See YSYS Variable for an explanation of coordinate-system.
ZSYS='coordinate-system'
specifies the coordinate system for the Z variable. See ZSYS Variable for an explanation of coordinate-system.