Previous Page | Next Page

SAS/GRAPH Output

Replacing an Existing Graphics Output File Using the GSFMODE= Graphics Option

You can use the GSFMODE= graphics option to replace an existing graphics output file with a new graph. To replace an existing graphics output file, the GSFMODE= option must be set to REPLACE, which is the default value for this option. When you run a SAS program that creates a graphics output file and the graphics option GSFMODE=REPLACE is used, the existing graphics output file is replaced with the new graph. However, a unique GRSEG is still generated each time you run the procedure.

See Introduction.

Previous Page | Next Page | Top of Page