Apply an ACT

  1. Open the object to which you are applying the ACT.
  2. Select the Authorization tab, and then click Open Authorization Information.
  3. On the Apply ACTs tab for an object, select the check box for the appropriate ACT.
    Tip
    You should not apply the repository ACT (which is usually named Default ACT) directly to any object. The repository ACT participates through inheritance, serving as an access control parent of last resort.
  4. On the Basic tab for the object, the identities that participate in the pattern of an ACT are listed. Verify that the revised settings are as you expect.
  5. Save your changes.
Copyright © SAS Institute Inc. All Rights Reserved.
Last updated: February 22, 2018