Apply an ACT

  1. Open the object to which you are applying the ACT.
  2. From the drop-down menu, select Apply ACT. On the Apply ACT page, select the check box for the appropriate ACT.
    Tip
    You should not apply the repository ACT (which is usually named Default ACT) directly to any object. The repository ACT participates through inheritance, serving as an access control parent of last resort.
  3. From the drop-down menu, select ACT: Pattern. The ACT: Pattern page lists the identities that participate in the pattern of an ACT. Verify that the revised settings are as you expect.
  4. Save your changes.