When a
job is executed, you want certain actions to be performed automatically
based on the status of the job.
Solution
You can
use the Status Handling tab in the properties
window for a job to specify one or more pairs of conditions and actions.
These conditions and actions apply to the job as a whole.
Perform
the following steps to specify actions to be performed automatically
based on the status of a job.
Right-click
the job in a tree view and select Properties from the menu.
Click
the Status Handling tab.
Click New. A default condition and action are displayed in
the first row of the table.
To replace
the default condition, use the selection arrow to select another condition,
such as Error.
To replace
the default action, use the selection arrow to select another action,
such as Send Email. If the action requires
information from you, the Action Options window appears.
Use the
Action Options window to specify any values that are required by the
action. For example, a Send Email action
requires an e-mail address.
Select
more conditions and actions, as desired.
Click OK to close the properties window.
Run the Job and Verify the Status Handling Output
Perform
the following steps to run the job and verify the status handling
output.
Right-click
the job in a tree view and select Open from
the menu. The job opens in the Job Editor.
Click Run.
If any
of the conditions that you specified are met, then the actions that
you specified should be performed.